MIL-A-81373(AS)
3.5.1
Function - The quantity select assembly shall limit the number of ripple
output pulses to the quantity selected by the pilot.
3.5.2
Form Factor - The quantity select assembly shall conform to the dimen-
sions shown in figure 2.
3.6
Design Data - No data is required by this specification (other than re-
ports accompanying samples submitted for testing) or by applicable documents, unless
specified in the contract or order (see 6. 7).
4.
QUALITY ASSURANCE PROVISIONS
4.1
Responsibility for Inspection - Unless otherwise specified in the contract
or purchase order, the supplier is responsible for the performance of all inspection re-
quirements as specified herein. Except as otherwise specified, the supplier may utilize
his own facilities or any commercial laboratory acceptable to the Government. The Gov-
ernment reserves the right to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure that supplies and services conform
to prescribed requirements.
4.1.1
Classification of Tests - Items covered by this specification shall be
subjected to the following tests to determine compliance with all applicable requirements:
(1) Preproduction tests
(2) Initial production tests
(3) Acceptance tests
(4) Life tests
4.2
Preproduction Tests - Preproduction tests shall be made on an equip-
ment representative of the production equipments to be supplied under the contract. Pre-
production tests shall be accomplished under the responsibility of the contractor and shall
be conducted in accordance with the approved test procedure of 4.6. The government
inspector and the procuring activity shall be advised when tests are to be conducted so that
a representative may be designated to witness or supervise the tests when so desired.
Contractors not having adequate facilities to conduct all required tests shall obtain the
services of a commercial testing laboratory acceptable to the Government.
4.2.1
Preproduction Test Data - The contractor shall submit all data collected
in conducting these tests to the procuring agency for review and approval. On first pro-
duction contracts this data shall include a list of all electrical and electronic parts giving
their specified voltage, current and temperature rating and the applied circuit voltage,
current and ambient and surface temperatures. The ambient and surface temperature
shall be obtained under the extreme high temperature operating condition.
4.2.2
Scope of Tests - Preproduction tests shall include all tests deemed nec-
essary by the procuring activity to determine that the equipment meets all the requirements
of this specification and the contract. Preproduction tests shall include environmental tests
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business